Thomashilfen RECARO Monza Nova 2 Reha Notice De Montage page 6

Turning plate with footrest adapter (accessory)
Sport
First clean the surfaces to be glued together. Place the child's car seat on its back. Clean the plastic areas on the
underside of the seat carefully by usual means (e.g. water and washing-up liquid) until they are completely free
from grease.
Now remove the top two Velcro strip (fleece) from the turning plate and peel off the white adhesive covering. Stick
the self-adhesive Velcro strip on the left and right of the cleaned underside of the seat so that lies flush to the front
edge (it is stuck up to the end at the rear (do not shorten). Press the Velcro strip firmly into place at all points and
leave for 24 hours. After 24 hours the adhesive connection achieves its final strength. (Fig. 1a) The opposite strips
(hooks) remain on the turning plate.
Turning plate with footrest adapter (accessory)
Monza
To connect the RECARO Monza Nova 2 Reha to the turning plate, the adapter plate first has to be installed on the
seat. In order to do so, remove the four screws (Torx T20) that are screwed into the seating shell of the RECARO
Monza Nova 2 Reha from below.
Hold the adapter plate against the underside of the seat so that the countersunk bores in the plate are on the bottom
and the wider end of the adapter plate is up against the rear end of the seat (Fig. 2a). Screw the plate onto the seat
with the supplied longer screws (Fig. 2b).
General safety instructions (only for the RECARO Monza Nova 2 Reha model) – except the
Please place your child into the RECARO Monza Nova 2 Reha seat slowly and very carefully – especially when
using the turning plate! If the seat is rotated around 90° when the child is put in/taken out of the seat the backrest
could suddenly fall backwards if pressure is applied!
The back stabilisers (RECARO Monza Nova 2 Reha optional extra, Art. 816, Fig. 2d) prevent the backrest of the
Monza Nova 2 model from accidentally folding down. This could happen if the pressure on the catch lip on the
backrest is too high when a child is placed in the seat or if they suffer a sudden spasm when using the turning plate
in a rotated position. You will then hear a loud click, but this does not indicate any damage. Press in the opposite
direction to lock the backrest into place. The catch lip can be removed if necessary.
Now position the seat at a 90° angle flush to the front of the turning plate (the turning plate handle points forwards)
Sport
&
and lower the seat onto the turning plate so that it is held in place by the Velcro strips. If you want to remove the
Monza
seat from the turning plate always do so by raising at the rear and tilting forwards. (Fig. 1b / 2c)
The turning plate is pre-assembled for mounting the car seat on the car's rear right seat. (Safe insertion and removal
of the child from the pavement side in countries that drive on the right.) If the child's seat is positioned on the left
side of the rear seat the turning plate's pivotal point has to be changed. To do so, simply move the Allen screw.
Note: The audible click into place of the turning plate only serves as an aid to orientation for a straight positioning
of the seat on the turning plate.
Transport: If transporting the seat with turning plate grasp the turning plate with one hand by the front handle and
hold the rear of the seat firmly in the other hand. The seat and turning plate can also be transported separately if
too heavy.
Footrest: The footrest is mounted on the underside of the turning plate with the adapter (location tubes).
6
Item code: 820
Item code: 820/1
version: