Warranty And After-Sales Service - ROBLIN 305.0488.079 Mode D'emploi Et D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
Clean the bodywork regularly using non-abrasive detergent products and a slightly damp sponge.
To renovate external stainless steel parts (at intervals of one year minimum), it is preferable to use the product ref.112.0172.941
Never use soaked sponges or rags..
Do not insert any object, or your hands, into the opening serving for the extraction of the air.
Clean the inside of the extraction body once per year.
Check the flow of stale air every 6 months.
Observe local regulatory requirements covering the extraction of stale air.
It is essential to clean anti-grease filters in a dishwasher at a maximum temperature of 50°C, once per month or according
to the indications on the order (see order page). Allow the filters to dry in the open air. These filters have a service life of 10
years.
If your hood is equipped with washable anti-odour filters
other kitchen utensils) every 2 months and dried by the dishwasher or in the open air for approximately 30 minutes.
Once washed and dried, reactivate the washable anti-odour filters by placing them in an oven for 10 minutes at 100°C maxi-
mum. Cleaning of the washable anti-odour filters should systematically be accompanied by cleaning of the anti-fat filters.
Active charcoal
hours per day. Or according to the indications of the order (see the order page). Replacement of the active charcoal anti-odour
filters should systematically be accompanied by cleaning of the anti-fat filters.
R
CLEAN-
The ultraviolet bulbs have a life expectancy of approximately 6000 hours. The life cycle of the clean-air filters (catalysts) fol-
lows that of the ultraviolet lamps.
The replacement of an ultraviolet bulb (every 3 years) should systematically be accompanied by the replacement of the asso-
ciated clean air filter.
The replacement of faulty LEDs should only be done by a certified professional specialist.
GB
IF AN ELECTRIC COMPONENT IS DAMAGED IT CAN ONLY BE REPLACED BY A REPAIR SHOP APPROVED BY THE MANUFAC-
In the event of faulty operation notify your installer who will check the appliance and its connection.
Disconnect the appliance completely.
Always require the use of genuine spare parts (non-compliance with this requirement can compromise the safety of the ap-
pliance).
When ordering spare parts, quote the serial number of the appliance (see on the page opposite) on the plate located inside
the hood.
Only the purchase invoice of the appliance can serve as proof for the implementation of the contractual warranty (this war-
ranty does not cover consumables such as: lighting, filters, LEDs, etc.).
anti-odour filters: (active charcoal filter (black appearance) and washable charcoal filter (similar appearance to the anti-grease filter but thicker and with a smaller circu-
(3)
10
Avoid fire risk by cleaning the hood according to the maintenance instructions :
Turn the hood off before any maintenance operation or electrical work. Wear gloves.
anti-odour filters need replacement at least every 3 months, or more often if the hood is used more than 3
(3)

WARRANTY AND AFTER-SALES SERVICE

TURER BECAUSE SPECIAL TOOLS ARE REQUIRED.
MAINTENANCE
, they must be cleaned in a dishwasher at high temperature (without
(3)
mference)) are always placed after the anti-grease filter; this is the first one visible.

Publicité

Table des Matières
loading

Table des Matières