Samsung SWA-9500S Manuel De L'utilisateur page 4

01 CHECKING THE
COMPONENTS
Surround Speaker X 2 (Left / Right) / Power Cord X 2
NOTES
• For more information about the power supply and power
consumption, refer to the label attached to the product.
(Label: Rear of the Main Unit)
• Design and specifications are subject to change without prior
notice.
02 CONNECTING THE
SWA-9500S TO A
SOUNDBAR
1. Check the standby status after plugging into
an electrical outlet
Plug the Surround Speakers power cord into an electrical outlet
and into the Surround Speakers to turn on the Surround Speakers.
The LINK LED indicator (blue LED) on the Surround Speakers blinks.
If the LED does not blink, refer to step 5.
Bottoms of the Left and Right Surround
Speakers
Rear of the Left and Right
Surround Speakers
English - 4
Blinking blue fast
2. Turn off the Soundbar
Turn off the Soundbar using the Soundbar's remote control or by
pressing the (Power) button on the main Soundbar unit.
• The image of the Soundbar may differ from your Soundbar,
depending on the model.
3. Configure "ID SET" using the Soundbar's
remote control
Press the Up button on the Soundbar remote control for 5 seconds.
• The ID SET message appears on the Soundbar main unit's display
for a short time and then disappears.
• After the ID SET process, the Soundbar power is automatically
turned on.
5 Sec
• The image of the Soundbar may differ from your Soundbar,
depending on the model.
4. Check if the LINK LED is solid blue
(connection complete)
Stops blinking.
Glows blue.
Rear of the Left
and Right Surround
Speakers
BYE
ID SET
The LINK LED indicator
stops blinking and glows
a solid blue when a
connection is established
between the Soundbar and
the Surround Speakers.
5.
L
L
•
•
S
S
•
C
•
R
•