Publicité
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open the vehicle's
trunk/tailgate..
3. Remove the interior trim
panel on the left (drivers) side
(Fig. 1).
4. Locate the vehicles tail light
wiring harness behind the trim
panel. It will have a connector similar to that on
the T-Connector harness (Fig. 2 A & B).
5. Press the T-Connector ends into the vehicle harness
connectors until they lock into place. Take care not to
damage the locking tabs.
6. Confirm correct operation with a
test light or by using a trailer.
7. Re-install the interior trim panel,
routing the T-Connectors 4-flat trailer
connector our under the panel.
8. Replace the threshold trim plate
to its original position using the
fasteners removed in step 2.
Fig. 2A
Fig. 1
Fig. 2B
Publicité
