Troubleshooting And Repair - Amsta AMDES112E Notice D'utilisation

3. Put the filter back.
TROUBLESHOOTING
If a condition listed below occurs, please check the following items before calling customer
service.

Troubleshooting and repair

Do not repair or disassemble the dehumidifier yourself. Any unqualified repair will result in device
failure and may damage users or their properties.
Problem
No power supply
Not working Water Full Indication Flashes
Room temperature ˂ 5°C, or ˃ 35 °C
Is the air filter clogged?
Bad functioning
Is the intake duct or discharge duct
obstructed?
No air Is the filter clogged?
intake
Loud noise
Is the machine put in the flat place?
when
running
Is the filter clogged?
E2 Humidity sensor problem
LO Environmental humidity is below 20%
HI Environmental humidity is above 90%
Low
CL
environmental temperature＜5℃
High
CH
environmental temperature＞35℃
Possible Cause
temperature protection,
temperature protection,
Connect to a functioning outlet and switch on
Drain water tank and reset it, or re-position the
water tank to right place
Self-Protection designed to protect the unit.
Cannot work under such temperature
Clean the air filter as instructed
Remove the obstruction from the discharge
duct or intake duct.
Wash the filter
Put the machine on the plat ground
Wash the filter
Change a sensor
the
The dehumidifier shuts down for self- protection
the
EN-18
Solution