Battery Replacement; Selecting A Location - STACK-ON PWS-15522 Instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BATTERY REPLACEMENT

NOTE: Do not mix old and new ba eries. Do not
mix alkaline, standard or rechargeable ba eries.
is safe uses 4 - AA ba eries. Under normal use,
ba eries will last about 1 year.
NOTE: If the ba eries are low, the yellow light will
ash when you start to enter your code.
To replace the ba eries, open the ba ery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install all new
ba eries.
TURNING THE KEYPAD SOUND
OFF/ON
Your safe comes with the "Beep" sound turned on.
You can turn o the "Beep" sound of the keypad
by pressing the
... key.
To turn the "Beep" sound on, press the
key again.

SELECTING A LOCATION

e safe is to be mounted in a wall between two
wall studs, and then secured to the wall studs.
For optimal safety and security, the safe should
be installed in an isolated, dry and secure area.
SECURING THE SAFE
NOTE:
then secured to the wall studs. Failure to do so
will compromise the safety and security of the
safe.
NOTE ON LOCKING THE SAFE:
needs to be in an upright position, as shown in
gure 1, for the locking mechanism to function
properly. Failure to mount the safe in the
corrrect upright position will compromise the
safety and security of the safe.
....
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
is safe must be mounted in a wall and
e safe
Figure 1
3
18
40537-1505

Publicité

Table des Matières
loading

Table des Matières