EDM PDFJY16DB Mode D'emploi page 28

33968
REF.
12
13
14
15
16
17
For Pedestal Fan
1. Remove parts from packaging. Set the fan
outer base (#16) on the floor, put the inner base
(#15) on and align the circle curves on both
bases. Insert lower column (#14) into the bases
and secure them with the plastic base locking
nut (#17).
2. Loosen the height adjustment locking nut
(#13) and pull up the adjustable column (#12);
hold desired height by re- tightening the height
adjustment locking nut (#13).
3. Place the upper column (#8) on top of the
adjustable column (#12). Tighten the upper
column knob (#10).
For Table Fan
1. Set the fan inner base (#15) on the table, insert
the connecting adapter (#19) into the base and
secure them with the plastic base locking nut
(#17).
2. Place the upper column (#8) on top of the
connecting adapter (#19). Tighten the upper
column knob (#10).
ASSEMBLY OF BLADE AND GRILLES(Fig.5, #1-7,
#20, #21)
1. Remove and discard the plastic sleeve on the
motor shaft (#7). Position the rear grille (#6)
against the front of the motor housing through
the motor shaft (#7). Ensure the handle at the
All manuals and user guides at all-guides.com
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
ASSEMBLY
Fig. 3
PEDESTAL BASE
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
Fig. 4
TABLE FAN BASE
back of grille (#6) is facing up and that all
guiding pegs on the motor housing are lined up
with cutouts on the rear grille (#6).
2. Secure the rear grille (#6) into place with the
plastic nut (#5). Fasten the plastic nut (#5) firmly
onto the motor housing (#7) by tightening it in a
CLOCKWISE direction.
3. Install the fan blade (#4) onto the motor shaft
(#7) with the cutouts fitted. Place spinner (#3)
on the motor shaft (#7) after the blade (#4).
Fasten into place by tightening the spinner (#3)
in a COUNTER-CLOCKWISE direction.
4. Fit front grille (#1) with front grille band (#2a)
against rear grille band (#2b) by aligning the
alignment mark on the top of the grille band,
closing them together by the hooks on front
grille band and slots on the rear grille band,
twisting the front grille clockwise to the lock
position (see Fig. 6), the snapping lock pin (#20)
should pop in.
Note: to disassemble the front grille, pull the
snapping lock pin while twisting the front grille
in counter clockwise direction.
5. Tighten the lock screw (#21) to secure the
snapping lock pin (#20).
19
15
17