Powering On And Off - Power smart DB5017 Manuel D'instruction

OPERATING INSTRUCTIONS
WARNING
Damaged electrical cords present risk of fire, electric shock, and serious bodily injury.
Before operating the snow thrower, carefully examine the electrical cord. Id the cord is damaged,
do not use the snow thrower. Replace or repair the damaged cord immediately. If you need
assistance, contact our customer service department at 1-800-791-9458.

POWERING ON AND OFF

1. Connect extension cord to the male plug on the
snow thrower then connect extension cord to proper
AC power source.
Press and Hold the start switch button
2.
3. To start, while holding the start switch button in,
pull the handle bar toward you until it touches
the handle. The start switch button must be pressed
in and held before pulling the handle. Once the snow
thrower starts, release the start switch button
To stop, Hold switch lever, Release starter button.
4.
14