Connection Diagrams - Alto Rmx1508Dfx Guide D'utilisation Rapide

CONNECTION DIAGRAMS

MAIN SPEAKER CONNECTION
Please use only the power connectors to make connections with other signal source equipment for the passive
speaker cabinets. In normal condition, the terminals 1+ and 1- of the speakon connecter can be connected. In bridge
mode, the terminals 2+ and 1+ of the speakon connecter can be connected.
This is the most common application. The built-in amplifier drives two main speaker cabinets Left and Right.
The AMPLIFIER MODE is on MAIN+MAIN position.
WARNING: In MAIN + MAIN mode, the speaker loads of OUTPUT1 and OUTPUT2 cannot be less than 4 ohm or it
will damage the unit.
Speakon connector
Main
Speaker
Main
Speaker
7
Use either the speakon jacks or
phone jacks