Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
electrician.
•
Periodically examine the power cord and machine
for damage. If any damage is found, do not use
the appliance but contact your service centre for
repair.
•
If the supply cord is damaged, it must be replaced
by the manufacturer, its service centres or
similarly qualified people in order to avoid a
hazard.
•
If an extension cord is used, the plug and socket must
be of watertight construction.
•
Before vacuuming liquids, check the float functions
correctly. When vacuuming liquids, and when the
tank is full, a float closes the suction opening, and the
vacuum operation is interrupted. Then switch off the
machine, disconnect the plug and empty the tank.
Regularly clean the water level limiting device (float)
and examine it for signs of damages.
•
If the machine overturns, it would be recommended
to stand it up before switching off.
•
If foam or liquid escape from the appliance, switch off
immediately.
•
The equipment should not be used to vacuum wa-
ter from containers lavatories, tubs, etc.
•
Aggressive solvents or detergents should not be
used.
•
Service and repairs must be carried out by qualified
personnel only. Only use manufacturer original spare
parts for service repair.
•
The manufacturer cannot be held responsible for any
damage/injury caused to persons, animals or property
caused by misuse of the appliance, not in compliance
with manual instructions.
USE
(see fig. ③④
• Be sure that switch is in off position (0) OFF and
connect the machine to a suitable socket.
• The machine must be always kept on horizontal bases,
in a safe and stable way.
• Insert the suitable filters for the proper use.
•
Never use the appliance without filters .
• Use the most suitable accessories for the requested
usage.
• Put switch on (I) ON position in order to start the
machine.
• When job is over, switch off (0) OFF and keep away the
plug from the socket.
• If the appliance is used with especially fine dust
(size below 0.3 µm) the filter supplied will require
cleaning more frequently. For especially demanding
applications, the use of specific filters supplied as an
optional (Hepa) may be necessary.
CARE AND MAINTENANCE ⑤
The unit is maintenance-free.
•
The machine shall be disconnected from its power
source, by removing the plug from the socket-outlet,
during cleaning or maintenance
• Clean the exterior part of the machine with a dry
cloth.
• Move the appliance only by catching the carrying
handle located on the motor head.
• Store the appliance and the accessories in a dry safe
place, out of the reach of children.
FILTER CLEANING R2
1- Remove the filter
2- Wash the filter
3- Let the filter drying befor reassemble it
•
Once the filter has been cleaned, check whether it
is suitable for further use. If it has been damaged or
broken, replace it with an original filter.
WARRANTY CONDITIONS
All our machines are subjected to strict tests and are co-
vered against manufacturing defects in accordance with
applicable regulations. The warranty is effective from
the date of purchase.
The following are not included in the warranty: - Parts
subject to normal wear. - Rubber parts, charcoal, filters
and the accessories and optional accessories. - Acciden-
tal damage, caused by transport, neglect or inadequate
treatment, incorrect or improper use and installation
failing - The warranty shall not cover any cleaning ope-
rations to which the operative components may be
subjected, such as clogged nozzles and filter blocked
due to limestones.
DISPOSAL (WEEE)
As the owner of electrical or electronic equipment,
the law (in accordance with the EU Directive 2002/96/EC
of 27 January 2003) prohibits you from disposing of this
product or its electrical / electronic accessories as mu-
nicipal solid waste and obliges you to make use of the
appropriate waste collection facilities.
The product can be disposed of by returning it to the
distributor when a new product is purchased. The new
product must be equivalent to that being disposed of.
9
Publicité
Table des Matières
