Weber Clean Track NANOscrub Manuel D'instructions page 45

7.14 SPECIFIC INSTRUCTIONS FOR THE USE
OF MODEL AC
The AC machine may be turned on only if the voltage
indicated on the tag corresponds with the available
voltage and that the electrical outlet is grounded
(earthed).
Do not damage the feed cable; do not crush or pull
on it.
• ATTENTION Make sure that the power cable
does not come into contact with the rotary
brushes.
• ATTENTION - The AC machine has parts,
which are connected to the current; contact
with these could cause grave injuries or even
death.
- Before executing any type of operation on the ma-
chine always disconnect it from the electrical source.
- Never touch electric cables that are defective or
worn.
- Before gaining access to the electrical system it is
always necessary to disconnect the machine from
the electrical source by removing the plug from the
socket-outlet.
- In the case of defective, damaged, or cracked
electric cables, replace immediately with authentic
replacement parts.
- The network of connections must be protected
from water spray.
- The patch cord for the connection of the ma-
chine to the mains power must conforms to
current safety rules.
- The electrical system to which the machine is con-
nected must be equipped with a cutout box.
- It is absolutely forbidden to use the machine in
proximity to swimming pools or stretches of water.
• EMERGENCY SITUATIONS
In case of emergency:
- Immediately disconnect the machine from
the power mains.
- Immediately apply proper first-aid.
If an accident should occur the machine must not be
put into operation until a technician authorized by
the manufacturer has examined it.
• Turn the key, remove it from the control panel
and disconnect the battery from the machine wiring.
☞ All work on the electrical system as well as all
maintenance and repair operations (especially those
not explicitly described in this manual) should be
carried out only by authorized service centers or by
specialized technical personnel who are experts in
7 - OPERATING INFORMATIONS
the sector and in the pertinent safety regulations.
Performing regular maintenance on the machine,
and carefully following the manufacturer's instruc-
tions, is the best guarantee for obtaining the best
performances and extended machine service life.
8. MAINTENANCE
8.1 TANKS
Drain the two tanks as described in the relative sec-
tions.
Remove any solid dirt by filling and draining the
tanks until all dirt has been eliminated: use a wash-
ing hose or similar tool to do this.
• Water hotter than 50°, a high-pressure
cleaner or excessively powerful sprays may
damage the tanks and the machine.
Leave the plugs of the tanks open (only while the
machine is not being used) so that they can dry and
thus prevent the formation of foul odors.
8.2 SOLUTION FILTER CLEANING
Remove the transparent cap ( Photo 29 - A ) then
remove the metal strainer.
Clean them, reinstall the metal strainer in its seat
and close the water filter screwing the transparent
cap.
8.3 SUCTION HOSE
Detach the suction hose from the squeegee ( Photo
23 - B ). Now you can wash the hose and remove
any obstructions.
Firmly insert the hose on the squeegee body.
8.4 SQUEEGEE
• Do not handle the squeegee with bare hands:
wear gloves and any safety clothing needed to carry
out the operation.
Detach the squeegee from the machine and clean
it under running water using a sponge or a brush.
Check the efficiency and the wear on the strips in
contact with the floor. They are designed to scrape
the film of detergent and water on the floor and to
isolate that portion of the surface to enhance the
vacuum of the suction motor: this ensures that the
machine will dry very efficiently. Working constantly
in this manner tends to round or to deteriorate the
sharp edge of the strip, thus reducing drying ef-
ficiently. This is why the squeegee strips must be
replaced.
To replace the worn blades, follow the instructions in
the relative section. Turn the blades around to wear
down the other sharp corners or to install new ones.
8.5 ACCESSORIES
45