Dmx Channels - ExPelec Nicols PAR COB 630 Manuel D'utilisation

Manuel d'utilisation
The light is available to receive the DMX512 signal, connect the DMX connector to the panel which
marked with "DMX IN", and connect it to the next light, then, connect to the "DMX IN" of next light from
the "DMX OUT", The DMX signal terminator is recommended when the lighting signal is connecting. It
will avoid to interfere the signal which caused by the electrical noise. DMX terminator is a XLR connector,
connect with a 120∩ resistor between the pin 2 and pin 3 of the XLR connector, and connect it to the
OUTPUT socket of the final light
See picture:

4. DMX CHANNELS

Channel
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
Channel address
0-255
1-255
1-255
0-255
0-255
0-255
0-255
PAR COB 630
Function
Dimmer
Strobe
Macro function
Macro function speed
adjust
Red dimming
Green dimming
Blue dimming
11