Publicité
Les langues disponibles
Les langues disponibles
young children for long periods of time.
• Do not place the appliance on a carpet while in use.
• Please do not use multiple plugs or extension cords.
• Please do not use this heater if it has been dropped
or if there are visible signs of damage.
Warning: In order to avoid overheating, do
not cover the heater!
Components (1)
1
Front
2
Air outlet
3
Fireplacesimulation
4
Base
5
Cord with power plug
6
On/Off switch
Installation
Please remove all packaging materials.
•
Place the unit on a table so that the bottom of the unit is freely accessible.
•
•
Please attach the base to the bottom of the unit by pressing the base against the bottom of the unit until
it clicks into place. Please set up the completely assembled appliance with the base.
Operation (2)
•
Operating voltage: 220-240V~, 50/60Hz, 2000W
•
Control panel:
1
Value increase/decrease for timer
2
On/Off
3
Heat setting
4
Eco mode
•
Please ensure that the unit is correctly positioned according to the safety instructions, then connect it to
the power supply.
Please tilt the switch on the back of the unit to the "I" position. An acoustic signal sounds and the unit is
•
put into standby mode.
To switch on the unit, press the on/off button on the control panel. Each operation on the control panel
•
is accompanied by an acoustic signal. The fan heater is activated with the following standard settings:
low heating level (1300W), target temperature 25°C, activated fireplace simulation.
The brightness of the LED display is reduced by 1/3 during operation if no adjustment is made after one
•
minute. The brightness is increased again as soon as any key is pressed.
Fireplace simulation
•
o
To switch the fireplace simulation on or off, press the corresponding key on the control panel.
The corresponding indicating light lights up or goes out. The fireplace simulation can be used
independently of the fan heater and also in standby mode.
Heating level
•
o
You may select from two heating levels using the corresponding button on the control panel:
The corresponding indicating light lights up.
Oscillation
•
o
To turn the 80° oscillation on or off, please press the corresponding button on the control
panel. The corresponding indicating light lights up or goes out.
•
Timer
low heating level (1300W)
high heating level (2000W)
7
Air inlet
8
Remote control compartment and handle
9
Back
10
Base
11
Control panel
5
Oscillation
6
Fireplace simulation
7
Value increase/decrease for temperature
8
LED display with value and indicating lights
Publicité
