Binatone FM-320 Manuel D'instructions page 6

SPECIAL SAFETY MEASURES
Never pour water into the appliance!
Pour the ceramic beads into the bath. The mas-
sage is performed by warmed ceramic beads,
not by water!
To avoid overheating your feet, put on socks
before the massage.
Never place the whole appliance in water.
Do not move the appliance or unplug from the socket during
operation of the appliance.
Do not stand in the appliance and only use it whilst in a sitting
position.
To avoid fire or electric shock, do not remove leads designed
for maintenance of the electrical appliance. The electrical ap-
pliance has no elements that require a service.
Avoid any water splashing into the controls.
Do not use for more than 20 minutes. After 20 minutes of
continuous work, the massager should be switched off and
allowed to cool to room temperature.
It is not advisable to use the massager if you have phlebitis,
varicose veins, severe leg edema, burns or open wounds,
diseases of the nervous system (for example, sciatica) or dur-
ing pregnancy. In the above cases, we recommend you to
consult your doctor before use of the massager.
When in use the appliance has a hot surface. Persons insensi-
tive to heat must be careful when using this appliance.
Empty the ceramic beads from the appliance though the spe-
cial cavity.
DESCRIPTION OF APPLIANCE
PARTS
Figure A:
1. Body
2. Lid
3. Operating mode switch:
0 - Off
1 - Heating
2 - Keep hot
3 - Keep warm
4. Removable massage attachments at the center of the appli-
ance.
5. Air venting holes
6. Surface for acupuncture massage
7. Heating area
8. Maximum level for filling with ceramic beads «MAX»
9. Bath emptying cavity
Figure B:
10.Non slip feet
11.Cord
12.Bottom compartment for dust removing with cover
5