Publicité
Les langues disponibles
Les langues disponibles
Installation of the shutter in the built-in mounting frame
1. Set aside the screws that are affixed to one of the cross slats, then unscrew the 4 cross slats of the mounting
frame and fold the 8 plates in the frame.
In the case of the EASY-KGC (MP) mounting frame, unfold the drop-guard grid (90°) in the shaft.
2. Rotate the four fastening plates on the damper 90° (to the upright position).
3. Open and position the shutter in the mounting frame. If VM magnet: remove the key from the lock to open
the shutter.
Fasten the shutter onto the mounting frame with the 4 screws supplied with the mounting frame, as shown
in the drawing. Tightening the screws pulls the shutter towards the wall until its final position. It also makes it
possible to slightly correct the angle of the shutter with respect to the mounting frame.
Connect the mechanism according to the wiring diagram.
Check the mobility of the shutter.
Product installation guidelines:
Kamouflage
Avantage
Avantage DP
Installation
(Images C)
Kamouflage MP
Kamouflage DP
9
Publicité
