G-Systems GSE EC Mode D'emploi page 34

EC fan controller with LCD display
Choose between Automatically, ON OFF (default is Auto.)
Choose between 0-10V or PWM pulse wide modulation. (default is 0-
10V).
Choose if the intake fan should stop running if the temperature and
humidity value is below them settings. (default is OFF)
Chose if you want to reset the controller to them factory settings. Push
the SET/SAVE button and the value will start blinking. Then press again and
hold for 4 seconds to reset.
Leave the sub settings menu
Push the UP button to confirm the setting and then push SET/SAVE.
The EC fan controller initializes with the new settings.
P-2 Back-light settings
P-3 Output signal
P-4 Intake fan settings
P-5 Reset to factory settings
EN
31