Assembly & Installation - Power Fist 8887176 Mode D'emploi

V1.0
4. Do not allow people, mobile equipment or vehicles to pass over
unprotected power cords.
a. Position power cords away from traffic areas.
b. Place cords in reinforced conduits.
c. Place planks on either side of the power cord to create a
protective trench.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
IDENTIFICATION KEY
A Carrying Handle
B Float Switch
C Pump Casing
D Discharge Outlet
E Intake
ASSEMBLY & INSTALLATION
When this manual refers to a part number, it refers to the included Parts
Identification section.
HOSE CONNECTION
IMPORTANT! All threaded connections must be sealed with thread sealing tape.
1. Connect the pressure pipe onto the pressure connection. For occasional
use, use a suitable water hose.
2. The use of rigid pipes with a non-return valve is recommended for use
at a fixed location. This prevents the return flow of liquid when
switching the pump off.
IMPORTANT! When using a hose, screw a suitable hose adapter onto the
pressure connection. Push the hose firmly onto the hose adapter and secure
with a hose clamp.
Visit www.princessauto.com for more information
1/2 HP Stainless Steel Submersible Sump Pump 8887176
7