Daga PM-145 Manuel D'instructions page 15

ENGLISH
Steps for taking a reading:
1) Press the on/off button (F).
2) The screen will display all the symbols of the same. You will then
feel a slight pressure on the cuff and the reading will commence. Do
not move or speak.
3) Once the pressure required is reached, it will start to deflate. If this
is not sufficient to take a reading, the device will automatically reinflate
to a greater pressure.
4) When the device detects a signal, the heart symbol will start to flash
on the screen.
5) Once the reading has been completed, the results of the reading will
appear on the screen.
6) The reading will be displayed on the screen until the device is turned
off. If you do not press any button for 3 minutes, the device will auto-
matically switch off in order to save energy
PLEASE NOTE: The irregular pressure indicator symbol (K) will appear
along with the results of the reading if any arrhythmia has been detec-
ted in the reading.
Rapid deflation during reading
If you feel unwell during the reading or you wish to stop the device for
any reason, you can press the on/off button for the device to quickly
release the air from the cuff and the device will return to standby mode.
Record of readings and viewing of readings on the device memory
The device automatically saves 2x90 reading results in its memory.
Once this goes over 60 readings, the oldest reading is replaced with a
newer one.
Pressing the memory button (D) with the device turned off displays
the average of the last 3 readings on the screen. Pressing the memory
button again displays the last reading taken, as well as the subsequent
readings every time that you press the memory button again.
Delete reading record from the memory
If you are sure that you want to delete all the records saved in the devi-
ce, press the MEM memory button for 4-6 seconds while the device is
15
in the read mode. The screen will display "dEL no", press the memory