Galletti AREO I Installation, Utilisation Et Entretien page 5

AREO i
FAN HEATER WITH BRUSHLESS INVERTER MOTOR
AREO I fan heaters are equipped with electric motor with permanent
magnets (brushless) which, controlled by an inverter, allows the
continuous variation of the number of revolutions of the fan.
The great advantage of brushless motors is the significant reduction
of electrical absorption, which during instantaneous reaches up to 2/3
compared with the absorption of conventional motors and in integrated
operation it stabilises at approximately 50%, with a corresponding
reduction in CO emissions!
2
DC Inverter technology allows you to continuously adjust the air flow
to the actual needs of the room thereby greatly reducing the
temperature fluctuations typical of interval adjustments.
The direct consequence is also the reduction of the level of noise
emission of the heater, which will now be adapted to the demands of
the environment.
CONTROL
Unit operation with brushless motor is operated from the control panel
with EVO or MYCOMFORT Large microprocessor, using an analogue
output (0-10V) that is connected to the inverter.
MAX speed
È severamente vietata la riproduzione anche parziale di questo manuale / All copying, even partial, of this manual is strictly forbidden
% Open
aver speed
min speed
Winter setting °C
Winter setting
AREO I fan heaters thus represent the state of the art also because
of the possibility of adjusting the operation, according to the
temperature of the air, its relative humidity, the water temperature and
based on programmable time bands.
Thanks to the digital outputs it is possible to switch on and off devices
which are external to the heater such as the chiller, boiler, zone
valves, water pumps etc.
An additional analogue output also allows you to manage modulating
valves.
5
GB
AP66000779 - 00