Frothing Milk - HAEGER D'Italia Série Mode D'emploi

Frothing milk

It is advised to froth the milk after the coffee had been prepared as milk frothing
mode requires a higher temperature. After milk frothing it is necessary to wait a
minimum of 5 minutes to allow the device to cool down slightly. If the
temperature of brewing is too high, the coffee can be scalded which will cause
the coffee to have a burned and bitter taste and aroma.
Before frothing ensure the volume of the milk is adequate in the cup. Milk can
double in volume after frothing, so care should be taken when deciding the
volume of milk.
Use a heat-resistant cup for milk frothing. The cup can get very hot during
frothing.
1. Turn on the milk frothing mode by pressing steam switch. The LED control light
will start to blink. When the light starts to shine continuously the device is
ready to generate steam.
2. Rinse the steam tube by turning the steam knob anti-clockwise. Steam and
some water will come from the steam wand. Turn off the steam by turning
the steam knob to the right in clockwise.
3. Immerse the steam tube into the cup with cold milk and turn the steam knob
to the left in anti-clockwise.
4. To end the milk frothing process turns the steam knob clockwise. Take out
the steam tube from the cup with milk. Never take the steam tube out of the
cup if the steam knob is not turned off. Hot steam may cause injuries and
scalds.
5. After milk frothing it is advised to put the steam tube into a cup with clean
cold water and rinse the system. After the steam tube is immersed in the cup
with water turn the steam knob anti-clockwise. After few seconds, turn off
the steam flow by turning steam knob clockwise.
6. Turn off the milk frothing mode by press the steam switch.
IMPORTANT:
 In choosing the size of jug, it is recommend the diameter is not less than
70±5mm, and bear in mind that the milk increases in volume by 2 times,
make sure the height of jug is enough.
 Never turn the steam control button rapidly, as the steam will accumulate
rapidly in short time which may increase the potential of the risk of explosion.
 During operation, if the blue indicator is extinguished, you should turn the
steam control leftwise. Press coffee switch and pump water, and then wait
for until the blue light is illuminated permanently and turn the steam control
knob in anti-clockwise, the steam will come out again.
 Clean steam outlet with wet sponge immediately after steam stops
generating, but care not to hurt!
Instructions for use
English
5