HAEGER D'Italia Série Mode D'emploi page 6

English
NOTE: The appliance is supplied with a detachable tank for easy cleaning,
you can fill the tank with water firstly, and then put the tank into the
appliance.
3. Plug in to a power source and turn the device on by pressing the ON/OFF
switch. The coffee maker will start to pre-heat and the blue LED will blink.
4. Choose the right filter (for two cups or for pod) and put it into the filter
holder.
5. When coffee maker is ready, the LED will stop blinking and shine
continuously.
6. Hold the filter holder below the boiler outlet and turn it to clockwise. Make
sure the handle of the filter holder aligns with groove in the appliance, then
move it to the right from the "INSERT" position to "LOCK" position.
7. Place a cup on removable shelf and press the button "coffee switch" and
wait for a few seconds, then press "coffee switch" again to close the flow of
the water. Pour out the hot water in the cup of preheating process.
8. Fit the suitable coffee filter into the filter holder. Use the pod cup filter or the
large 2 cup filter for two cups of espresso. Fill the filter using the measuring
spoon. Clean away any coffee that may remain around the edge of the
filter holder. The coffee powder could not exceed the max level in the filter
after being pressed.
9. Place the filter holder into its housing. Turn the filter holder round to the right
until you notice it is stopped. Do not force it.
10. Place cups under the outlets of the filter holder.
11. Press "coffee switch" and wait for the right amount of coffee to pour into the
cups then press "coffee switch" again.
WARNING Do not leave the coffee maker unattended during making the
coffee, as you need operate manually sometimes!
12. After finishing making the coffee, you can take out the filter holder, lock the
filter by filter lock bar and pour out the coffee residue.
13. Let them cool down completely, then rinse under running water.
IMPORTANT NOTICE
You cannot start to make espresso until the ready light glows because it
means the water temperature is not enough. To avoid water leakages from
the rim of filter holder and to ensure optimum performance, it is necessary to
clear any ground coffee from around the boiler outlet. Take care as the
area may be hot.
4 Instructions for use