Sauder Heritage Hill Library 102795 Mode D'emploi page 9

Step 6
Fasten the remaining LOWER END (A2) to the FIXED SHELF (BB)
å
and SHELF (B). Tighten four HIDDEN CONNECTORS.
Fasten nine ANGLE BRACKETS (L) to the LOWER ENDS (A2) and
å
SHELF (B). Use nine BLACK 9/16" LARGE HEAD SCREWS (T).
NOTE: Be sure the edges of the ANGLE BRACKETS are even with
å
the edges of the LOWER ENDS and SHELF.
Fasten the BASE (I) to the LOWER ENDS (A2) and SHELF (B). Use
å
fi ve BLACK 9/16" LARGE HEAD SCREWS (T) through the ANGLE
BRACKETS and into the BASE.
Fasten the SHORT END MOLDINGS (E) to the LOWER ENDS (A2).
å
Use four BLACK 9/16" LARGE HEAD SCREWS (T) through the
ANGLE BRACKETS and into the grooves in the MOLDINGS.
NOTE: The ENDS MOLDINGS should rest against the BASE.
å
IMPORTANT
The END MOLDINGS (E) are off set 1/4" in
from the edges of the LOWER ENDS (A2).
A2
Curved edge
Groove
www.sauder.com/services
E
I
B
A2
Flat edge
L
BB
E
S
O R
u t
i t h o
E C T
e w
N N
f a c
C O
S u r
D E N
H I D
Curved edge
Groove
102795
BLACK 9/16" LARGE HEAD SCREW
(18 used for the ANGLE BRACKETS)
(9 used)
L
T
L
Page 9