Cleaning And Care - Binatone EEJ-1555 Manuel D'instructions

5. Close the lid (3) and put the appliance onto the base (9).
Warning: check the correct positioning of the appliance –
the water dispenser (6) should be under the tray for
drops.
Warning: make sure that the power on/off switch is not
pressed.
6. Plug the power cord into a wall outlet with the same voltage as
indicated on the appliance. Your appliance dispenses 250ml of
boiling water each time (approximately equivalent to a stan-
dard mug). Place a suitable cup containing a tea bag, coffee,
sugar, etc. below the dispensing nozzle (6) on the metal pro-
tection cover (8).
7. Switch the appliance on by pressing the power on/off switch
(2). After that, the indicator light on the power on/off switch
(2) will flash on as well as the inside backlighting of the water
container (5) to indicate the beginning of the boiling process.
Few seconds before the end of the boiling process the power
on/off switch (2) will automatically go back to the initial posi-
tion.
8. 250ml of boiling water will be dispensed into the cup. Your
appliance is now ready to use again. If, after just having boiled,
the on/off switch doesn't stay in the on position, wait a few
seconds before trying it again. The appliance should cool down
a bit.
Attention: beware of accidentally operating the on/off
switch. If you do, immediately switch it off again.
Attention: if your appliance has been switched on for more
than 15 seconds, hot water will still be dispensed. Do
not attempt to move your appliance from the base.
Allow the water to escape into the drip tray. Beware
of hot water splashing from the drip tray.
Attention: if you have started the boil procedure and then
decide to switch off your appliance, always allow it to
stand for 1 minute before removing it from the power
base for refilling etc.

CLEANING AND CARE

1. Before cleaning or storing disconnect the
appliance from the mains supply and wait till it
cools completely.
2. To avoid electrical shock, do not place the
body of the appliance (1), its base (9) and
electrical cord in water. These parts of the ap-
pliance can be cleaned with a damp lint free
cloth. You can use non-abrasive cleansers.
9