Ermax Sportivo Notice De Montage page 2

WINDSHIELD FOR VESPA
Sportivo
Conical counterskunk
Rubber
head screw
washers
Chrome
washer
Holed cylinder
ASSEMBLY
On each bar:
- tighten the long nut (by the smooth side) on the bar until the end of the thread.
- assemble the rest i the following order : 1 wide conical washer Ø 8,5 , 2 steel half-cylinders
(held together by O-ring in the furrow), 1 narrow conical washer Ø 8,5 and 1 Nylock nut M8
(see draw).
- Tighten the nut M8 staying flush with the end of the rod in order not to jam the rest of the
assembly.
- Insert the bar ( the side previously assembly) into the provided hole on the original handle bar
of the scooter, then, once i full lock, tighten the long nut.
-Place the 4 holed cylinders on both bent fitting bars.
On the windshield :
- Enter the screw in the chrome washer, then the rubber washer, the windshield and the other
rubber washer.
-Screw the windshield on the holed cylinders and tighten the screws once the winshield
adjusted with the outline of the headlight.
Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged. Ermax accessories are foreseen for original
equipments. They will not be guaranteed if they are used in others conditions. Due to vehicles made tolerances, beyond our control, some Ermax products might need
adjusting to fit.
®
Long threaded sleeves/nut
Half cylinder
O-ring
long M8
Nylock nut M8
50/125/250/300 GTS/LX 2007 à 2010
Mini Sportivo
&
FITTING KIT
- 2 bent chrome fitting bars Ø10
- 4 steel half-cylinders
- 4 chrome washers Ø6
- 2 Nylock nuts M8
- 4 holed cylinders L: 30mm
- 2 conical wide washers Ø8,5
- 2 long threaded sleeves/nuts M8
- 2 O-rings Ø17
- 8 rubber washers Ø6
- 2 narrow conical washers Ø8,5
Conical
washer
« CAUTION »
English
®
(for bars)