Pre-Installation; Planning Installation; Tools And Hardware Required - Glacier bay HD873X-2201 Guide D'installation Et D'entretien

Pre-Installation

PLANNING INSTALLATION

ADVANCED INSTALLATION: Consult a plumber or
professional before installing this product.
Before beginning the installation of this product, ensure all parts are present. Compare parts with the Package
Contents list. If any part is missing or damaged, do not attempt to install the product. Contact customer service
for replacement parts.
All installations can vary depending on how your previous faucet was installed. Not all supplies for faucet
installation are included; however, they are available wherever plumbing supplies are sold. When choosing your
installation supplies, make sure they are UPC and/or CSA approved products.

TOOLS AND HARDWARE REQUIRED

If you are replacing your plumbing valve, please review the four common plumbing methods illustrated below:
COPPER, IPS, PEX and CPVC. Remove the existing handle and valve trim before replacing your valve. Please follow
all local building and plumbing codes.
A. COPPER (Before soldering, remove the cartridge & stop valves from the valve)
Safety Measuring
goggles
Phillips
Adjustable
screwdriver
wrench
Strap wrench
Tube
tape cutter
Flathead
screwdriver
Torch Lead-free solder Kit
Key
Thermometer
hole saw
Silicone
Flashlight
sealant
3
Please contact 1-855-HD-GLACIER for further assistance.
Thread
sealant tape
Wire
brush
HOMEDEPOT.COM