Functional Description - ITC SCT512 Mode D'emploi

SPECIFICATIONS
Your new ITC 011106 comprises:
= Cordless Drill
= 2 batteries
= 1 hour charger
= 1 magnetic hex driver extension
= 6 -¼" hex screwdriver bits
= 6 drill bits
= 2 double-ended screwdriver bits (stored in clips on
the drill handle)
= 1 blow-mould plastic case

FUNCTIONAL dESCRIPTION

A NiCd battery
B Variable speed trigger
C 3/8" (10 mm) chuck jaws
D Chuck-opening ring
E Shaft control ring
F Clutch selection ring
G Torque selection scale
H Indicator arrow
I Gear selector
J Bubble vial level
K Cooling vents
L Forward/Reverse/Lock button
M Handle
N Double-ended driver bit
O Battery lock/release tab
WARNING! For your own safety do
!
not attempt to use your electrical tool
until the battery is fully charged and
you have read all the instructions
REMEMBER: This cordless tool is
always in an operating condition and
does not need to be plugged in to a
wall socket power supply before it can
cause injury.
CAUTION!
= Do not expose either the electrical
tool or charger to rain or water.
= Do not overcharge the battery as
this could damage the cells.
= Do not force the tool. If the tool
is labouring, it is possible that the
battery power is low. If so, stop
working and recharge the battery
pack.
= To prolong the life of the tool, do
not continually work more than 15
minutes at a time.
4
= Voltage:18 volts DC
= No load speed: variable in two ranges:
0~350 rpm / 0~950 rpm
= Reversible with electric brake
= Chuck: 3/8" (10mm) Keyless
= Charger: 1 Hour Quick cUL & UL Approved
= Batteries: 1,300 mAh NiCd rechargeable
= Torque: 20 Setting Clutch (plus drill setting)