Changing The Power-On State - Keysight U3606B Mode D'emploi

Masquer les pouces Voir aussi pour U3606B:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4
System-Related Operation
– When a measurement exceeds the high (HI) or low (LO) limit value.
– When a forward-biased diode is measured in the diode function.
– When a continuity measurement is less than or equal to the continuity
– When a SYSTem:BEEPer command is sent from the remote interface.
– When an error is generated.
Press [ ] or [ ] to change the beep driving frequency. Select "oFF" to disable
the beeper.

Changing the power-on state

The following procedure shows you how to enable or disable the automatic recall
of the power-off state when the power is turned on. For remote interface
operation, refer to the MEMory:STATe:RECall:AUTO command in the U3606B
Programmer's Reference.
Press [ ] or [ ] to change the power-on state.
– Select "rESEt" to automatically reset the instrument to the factory default
– Select "LASt" to automatically recall the last power-off state of the instrument
162
threshold.
state when the power is turned on.
when the power is turned on.
Keysight U3606B User's Guide

Publicité

Table des Matières
loading

Table des Matières