Thitronik GBA-I Mode D'emploi page 3

Congratulations on buying an approved quality product meeting interna-
tional standards, made by Thitronik. GBA-I reliably alerts you in case of
narcotic gas attacks or gas leaks. The dynamic temprature compensation
and the continuous sensor self test ensure a reliable operation even under
different climatic conditions.
Mounting locations:
Choose a location underneath the sleeping-places, approx. 10 cm above
the floor. Avoid vicinity to heater outlets and lead-acid-batteries. GBA-I
is not to be used in bathrooms.
Minimum seperations:
Heater outlets
Lead-acid-batteries
Installation:
Mount GBA-I to a wall or closet using the drilling template (Scetch 2)
and the provided screws. !!!Attention!!! screw-in-depth (scetch 1)!!! Plug
the connection cable in the socket until it locks audible. You can lay the
cable either through the wall or the small predetermined breaking point
underneath the
pushbutton (A).
Interconnections:
Connect the cable to an appropriate powersupply (12/24VDC)
brown: +12/24V
white: Gnd (ground)
green: not used
To operate GBA I at 230VAC the optional wall plug transformer
(Art. Nr.: 100083) is to be used instead of the connection cable.
Operating:
- switch on GBA-I with pushbutton (A).
- The operating indicator (B) switches from yellow to green after a few
seconds. (at first activation up to 20 minutes)
- After appx. 4 min. heating phase indicated by the green indicator GBA I
will be ready to detect gases. Indicator will flash green.
Sensor error
If a sensor error is detected during the self-test, the device indicates
this by a yellow steady light of the operating indicator (B). There also an
continuous beep sounds. The device must be replaced.
Technical specifications:
Power supply:
Current consumption: appx. 70 mA
Weight:
Detection:
Delivery scope:
GBA-I, power cable, alarm sticker, manual, mounting materials
Warranty: 24 months from date of purchase
English
1,5 m
1,0 m
12/24 VDC
appx. 60 g
from 50 ppm narcotic gas, Propane, Butane