Auxiliary Contacts; Warranty - Liberty Pumps ALM Serie Manuel D'installation Et D'utilisation

Masquer les pouces Voir aussi pour ALM Serie:

Manuel d'installation et mode d'emploi (7 pages)

Manuel d'installation (7 pages)

Table des Matières

Les langues disponibles

Installation (con't)

This device comes equipped with auxiliary contacts. These contacts can be used to integrate the output of this alarm

with an existing home monitoring system. See Figure 6 for contact connections diagram.

Contact Rating: Class 2, 24 VDC/VAC (50/60 HZ) 500 mA MAXIMUM

Now that your alarm unit has been configured and tested, it is ready for operation. The following is a list of regular

maintenance tasks:



It is highly recommended that the alarm system be tested every 6 months. Follow the procedure outlined in the

Alarm Testing section above.



In the event the 9V battery is low, the alarm will emit a short chirp about twice per minute. The 9V battery should be

replaced any time the yellow "low battery" indicator on the alarm unit is lit or every 12 months.

In the event that an alarm condition is detected by the system, the audible and visual alarms will activate. The automatic

reset feature of the alarm will turn the audible and visual alarms off once the condition has been corrected.

If your system already has an alarm float installed, and you do not want to replace it with the float included with your

Liberty ALM series product, you can use the included terminal block adapter.

1) Turn both screws in the float adapter counter-clockwise, until the conductor receptacles are fully open.

2) Insert the float conductors into the float adapter, one conductor per

receptacle. Polarity does not matter.

3) Tighten the screws in the float adapter until they bottom out.

4) Insert the float adapter into the connector on your Liberty ALM series

alarm.

3 Year Limited Warranty

Liberty Pumps, Inc. warrants that its products are free from all factory defects in material and workmanship for a period

of 3 years from the date of purchase. The date of purchase shall be determined by a dated sales receipt noting the

model and serial number of the pump. The dated sales receipt must accompany the returned pump if the date of return

is more than 3 years from the "CODE" (date of manufacture) number noted on the pump nameplate.

The manufacturer's sole obligation under this Warranty shall be limited to the repair or replacement of any parts found

by the manufacturer to be defective, provided the part or assembly is returned freight prepaid to the manufacturer or its

authorized service center, and provided that none of the following warranty-voiding events have taken place.

The manufacturer shall not be liable under this Warranty if the product has not been properly installed; if it has been dis-

assembled, modified, abused or tampered with; if the electrical cord has been cut, damaged or spliced; if the pump

discharge has been reduced in size; if the pump has been used in water temperatures above the advertised rating, or in

water containing sand, lime, cement, gravel or other abrasives; if the product has been used to pump chemicals or hy-

drocarbons; if a non-submersible motor has been subjected to excessive moisture; or if the label bearing the serial,

model and code number has been removed. Liberty Pumps, Inc. shall not be liable for any loss, damage or expenses

resulting from installation or use of its products, or for indirect, incidental, and consequential damages, including costs of

removal, reinstallation or transportation.

THE WARRANTIES SET FORTH ABOVE ARE IN LIEU OF ALL OTHER WARANTIES, EXPRESSED OR IMPLIED,

INCLUDING WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR

PURPOSE, AND ALL SUCH OTHER WARRANTIES ARE HEREBY DISCLAIMED AND EXCLUDED BY LIBERTY