Tips For Best Results - Swiffer WETJET Guide De L'utilisateur

Use the right cleaning
solution for your needs.
WetJet has Multi-purpose,
Antibacterial, and Wood
Floor Cleaning solutions
available for your use.
Bottles can be interchanged
without risk of leakage.
Push
button
to release
bottle

Tips for Best Results

Sweep or vacuum before mopping with the Swiffer WetJet.
Spray for at least 3-4 seconds per 10 sq ft. It is important that you spray
the right amount of cleaning solution to get the best results.
When the WetJet cleaning pad appears too dirty, remove it from bottom
of device head and throw it away.
When the WetJet solution is empty, remove it by pushing the purple release
button on the device and throw it away. You may change the bottle at any
time because its cap is specifically designed not to leak.
Floor Information
Swiffer WetJet cleans the following types of floors:
Wood and Marble
Laminate
Do not use on unfinished, oiled or waxed wooden boards, on non-sealed tiles,
and carpeted floors.
Floor Safety Test
In case you would have any doubt regarding the surface safety of the Swiffer WetJet solution
on the type of finishing of your floor, spray a small amount of solution on a small, inconspicuous
area of the floor. Once completely dry, if a small white circle appears, the floor probably has a wax
or oil finish. You can remove the small white circle by re-applying a small amount of wax finish.
Stone Tiles Ceramic Tiles Vinyl
7