Samsung AKG VL Serie Mode D'emploi page 10

Rear of the Speaker
❚
SERVICE
RESET
POWER
RESET
(DC IN)
CONNECT
SERVICE LAN
AUX IN
DC 24V
POWER
NETWORK
SERVICE LAN
AUX IN
POWER (DC IN)
1
Jack
CONNECT
2
Button
3
LAN Jack
4
AUX IN Jack
5
SERVICE Jack
 Use Cat 7 (*STP Type) cable for the connection. (* Shielded Twisted Pair)
 The
RESET button is for troubleshooting.
DC 24V
POWER
NETWORK
LAN
AUX IN
1. Connect the power cord to the AC/DC adapter.
(Dedicated for VL550 / VL551)
2. Connect the AC/DC adapter output power cord (round plug) to the
POWER (DC IN) port on the speaker.
Press : To disconnect from or reconnect with the Dial Controller.
Long press it for 5 seconds : To initiate Wi-Fi connection.
Used to connect the speaker to the wired network.
Connect it to the analogue output port on an external device.
Used to update the speaker firmware by a service engineer.
POWER
RESET
(DC IN)
CONNECT
SERVICE LAN
AUX IN
DC 24V
POWER
NETWORK
SERVICE LAN
AUX IN
ENG - 5
RESET
1
RESET Button
2
3
4
5