Regulatory Information - Samsung SyncMaster 750p Instructions Pour L'utilisateur

Regulatory Information

FCC Information
User Instructions
The Federal Communications Commission Radio Frequency
Interference Statement includes the following warning:
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television receptions, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
Consult the dealer or an experienced radio/TV tech-
nician for help.
User Information
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
If necessary, consult your dealer or an experienced radio/televi-
sion technician for additional suggestions. You may find the
booklet called How to Identify and Resolve Radio/TV Interfer-
ence Problems helpful. This booklet was prepared by the Federal
Communications Commission. It is available from the U.S. Gov-
ernment Printing Office, Washington, DC 20402, Stock Number
004-000-00345-4.
Warning
User must use shielded signal interface cables to maintain FCC
compliance for the product.
Declaration of conformity for products
Marked with FCC Logo
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
The party responsible for product compliance:
SAMSUNG ELECTRONICS CO., LTD
America QA Lab of Samsung
85 West Tasman Drive
San Jose, CA 95134 USA
Tel) 408-544-5124
Fax) 408-544-5191
Provided with this monitor is a detachable power supply cord
with IEC320 style terminations. It may be suitable for connection
to any UL Listed personal computer with similar configuration.
Before making the connection, make sure the voltage rating of
the computer convenience outlet is the same as the monitor and
that the ampere rating of the computer convenience outlet is
equal to or exceeds the monitor voltage rating.
For 120 Volt applications, use only UL Listed detachable power
cord with NEMA configuration 5-15P type (parallel blades) plug
cap. For 240 Volt applications use only UL Listed Detachable
power supply cord with NEMA configuration 6-15P type (tandem
blades) plug cap.
IC Compliance Notice
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations of ICES-
003.
Cet appareil Numérique de classe B respecte toutes les exi-
gences du Règlemont ICES-003 sur les équipements produisant
des interférences au Canada.
MPR II Compliance
This monitor complies with SWEDAC(MPR II) recommendations
for reduced electric and magnetic fields.
European Notice
Products with the CE Marking comply with both the EMC Direc-
tive (89/336/EEC), (92/31/EEC), (93/68/EEC) and the Low Voltage
Directive (73/23/EEC) issued by the Commission of the European
Community.
Compliance with these directives implies conformity to the fol-
lowing European Norms:
EN55022 (CISPR 22) – Radio Frequency Interference
EN50082-1 : 1992 – Electromagnetic Immunity
EN60555-2 (IEC555-2) – Power Line Harmonics
EN60555-3 (IEC555-3) – Voltage Fluctuations
EN60950 (IEC950) – Product Safety.