ABC Design 3Tec PLUS Instructions De Service page 14

15. Adjusting the seat to full recline position
a. Move the seat angle to its lowest position.
b. The release catch for the folding mechanism is located on the underside of the seat. Reach through the
opening between the seat and leg rest in order to take hold of the release.
c. Rotate the mechanism in the direction of the seat and move the seat to full recline position.
NB: The seat can only be fully reclined if the seat angle has been set to its
lowest position first.
16. Extending the hood
a. Undo the zip fastener on the hood.
b. Open the hood out over the pushchair.
c. In order to return the hood to its original position, fold it back down and close the zip fastener.
17. Adjusting the seat to upright position
In order to move the seat from reclined to upright position, lift the footrest up until the mechanism engages.
CAUTION: Ensure that all the catches are engaged before use.
18. Folding the pushchair
a. Press and hold in the release mechanism buttons on both sides of the pushbar. Pull the release
mechanisms up.
b. Fold the pushbar down.
CAUTION: Ensure that all the catches are engaged before use.
EN - 08