Jeulin Ex.A.O. 453 076 Mode D'emploi page 16

Data logging
Erreur ! Source du renvoi introuvable.
Ref : 453 076
9- Making of the calibration solution : pour 20 ml of base solution into a flask.
Add 3 ml of acid solution.
10- Put the probe into the calibration solution.
The displayed value remains the same.
Caution : the lifetime of the solution is 10 to 15 min. If exceeded, make a new
solution.
11- When the arrows blink alternately
Turn the potentiometer
12- If the setup is OK a triangle appears above the pictogram « OK ».
In case of probe failure, a triangle appears above the pictogram
The probe is ready to be used in Air or Water !
13- Rinse the probe with distilled water, dry it (avoid touching the membrane) and let it in
the air.
The value displayed must be around 0.
ENGLISH
, the probe is ready to be setup.
until the value 5,8 is displayez then press the setup button
15
.
.