Operating Cautions; Cleaning Cautions; Operating Your Nebulizer - Drive Medquip AIRIAL MEDNEB MQ5600 Mode D'emploi

Operating Cautions:

1. Only connect this product to an appropriate voltage outlet for your model.
2. Do not run this product unattended.
3. Never operate this unit if it has any damaged parts (including a power cord),
or if it has been dropped or submersed in water. If for any reason this unit
does not work properly, promptly return it to an authorized service center for
repair.
4. If any abnormalities occur, discontinue use immediately until the unit has
been examined and repaired.
5. Always unplug the product immediately after use.
6. Never block the air openings of the main unit or place it where the air
openings may be obstructed.
Storage Cautions:
1.
Do not store the unit under direct sunlight, high temperature or humidity.
2. Keep the unit out of reach of small children.
3. Always keep the unit unplugged while not in use.

Cleaning Cautions:

1. Do not immerse the unit in water. It may damage the unit.
2. Disconnect the unit from the electrical outlet before cleaning.
3. Clean all necessary parts after each use as instructed in this guidebook.
4.

OPERATING YOUR NEBULIZER

Important: Prior to initial operation, this product should be thoroughly
cleaned per the "Cleaning Procedures" in this guidebook..
1. Place your Compressor Nebulizer on a at and stable surface. Be sure that you
can easily reach the controls when you are seated.
2. Gently twist the top part of the nebulizer cup counter-clockwise to disassemble
the nebulizer cup.
3. Fill the bottom section of the nebulizer cup with
the medication prescribed by your physician. Be
sure that the cone is put inside the bottom
section.
4. Gently twist the top part clockwise to reassemble
the nebulizer cup. Be sure the two sections t well.
5. Attach one end of air tube to the base of the nebulizer cup.
6. Attach the other end of air tube to the air tube connector located on the top
front of the compressor.
7. Attach the interface accessory of your choice to the top section of nebulizer cup.
8. Plug the power cord into an appropriate electrical outlet. Make sure at this
stage, the power switch is at "OFF" status.
9. Press the power switch to "ON" status to begin your prescribed treatment.
All manuals and user guides at all-guides.com
4
Place cone inside
and ll medication.