Cequent Performance Products 75892 Instructions D'installation

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75892F
Wrenches: 18 & 19mm
Drill Bits: None
Fasteners typical for all
mounting locations
j
Qty. (5) Hex Bolt M12 x 1.25 x 35mm CL8.8
1. Remove and return factory tow hook and fasteners to vehicle owner.
Raise hitch into position on driver's side and loosely install center fastener as shown, installing hex bolt and conical washer thru
2.
elongated hole in hitch into vehicle frame. Raise hitch into position on passenger's side and loosely install center fastener as
shown, installing hex bolt and conical washer thru elongated hole in hitch into vehicle frame. Center hitch on vehicle and install
remaining hardware as shown.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2014 Cequent Performance Products – Printed in Mexico
Installation Instructions
Tighten all M12 x 1.25 CL8.8 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Nissan Rogue
(Except Krōm)
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distribution
Weight Carrying
Ball Mount
Wiring Access Location: SUV1 & SUV2
kj
k
Conical Washer ½"
Qty. (5)
Sheet 1 of 3 75892N
Part Numbers:
75892
87657
44708
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
Not to be used with Spring bars
3500 (1590 Kg)
Factory Tow Hook
Vehicle Frame
1/14/14
Form: F205 Rev A 5-6-05
Max Tongue
WT (LB)
350 (159 Kg)
Rev. A