Cequent Performance Products 75806 Instructions D'installation

Frame rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75806F
Wrenches: 22MM
Drill Bits: None
1 1 1 1
Qty. (6) M14 x 1.50 x 45 Bolt CL10.9
1. Lower and remove spare tire from vehicle.
2. Raise hitch into position and insert M14 bolts and conical washers through the bracket and frame as shown in Figure 1.
3. Reinstall spare tire and make sure it is seated properly
4. Torque all fasteners to the specifications shown below.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2013 Cequent Performance Products, Inc.
Installation Instructions
Fascia
Figure 1
Tighten all M14 CL10.9 fasteners with torque wrench to 100 Lb.-Ft. (136 N*M)
Acura MDX
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1, SUV2
2 2 2 2
Qty. (6) 5/8 Conical washer
Sheet 1 of 3 75806N
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
8000 Lb (3628 Kg)
6000 Lb (2724 Kg)
Accessory Rating
12
Fasteners typical both sides
08/07/13
75806
44700
87649
Max Tongue
WT (LB)
900 Lb (409 Kg)
900 Lb (409 Kg)
C
Rev.A
Form: F205 Rev C 9-17-2012