Abus GWM100ME Manuel D'utilisation page 20

Installation:
Warning
• When marking out the drill holes, make sure there are no electrical
wires or cables, pipes or other important components behind them!
If possible, work with a locating device (cable detector)!
Mounting steps
1. Disconnect the bracket (2) from the alarm body (1).
2. Hold the bracket at the mounting location on the wall and mark the two drill
holes (6).
3. Drill two ø 5 mm holes in the wall, then insert the plastic plugs (5) into the holes.
4. Attach the bracket to the plastic plugs and fix tightly the screws (4) into the plugs.
5. Fit the gas alarm on the bracket and pull it down until matching well on the
bracket.
6. Insert the power plug (3) into the socket.
3
1
2
4
– 20 –
5 6
Mounting