Switching The Product On/Off; Cleaning And Maintenance - BASETech 1664136 Notice Originale

d) Switching the product on/off
After tightening the screw/nut, the product's impact mechanism starts to "bump". The maximum impact
duration should not exceed 1-2 seconds.
The product is equipped with the work light (3) to illuminate the work area. The work light turns on when the
product is in operation, and turns off automatically when the product is off.
1. To switch on the product, press the on/off switch (4) (Ú Fig. 5).
2. To switch off the product, release the on/off switch (4).
The speed of the power tool can be adjusted by pressing the on/off switch (4) to varying extents. A light
pressure on the on/off switch results in a low rotational speed. Increased pressure on the switch causes an
increase in speed.

9. Cleaning and maintenance

Switch the product off and remove battery pack before assembly, cleaning, adjustments, maintenance,
storage and transportation. Also disconnect the charger from the mains.
• Regularly check for obvious defects such as loose fixings, and worn or damaged components.
• Check that parts and correctly fitted. Carry out necessary maintenance or repairs before each use.
Under no circumstances use aggressive cleaning agents, cleaning alcohol or other chemical solutions to
clean the housing of the product.
24
Fig. 5