Residual Risks; Service; Drill Safety Warnings - BASETech 1664136 Notice Originale

• Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or burns.
• Do not use a battery pack or tool that is damaged or modified. Damaged or modified batteries may
exhibit unpredictable behaviour resulting in fire, explosion or risk of injury.
• Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire or
temperature above 130 °C may cause explosion.
• Follow all charging instructions and do not charge the battery pack or tool outside the
temperature range specified in the instructions. Charging improperly or at temperatures outside the
specified range may damage the battery and increase the risk of fire.
f) Residual risks
Even if you are operating this product in accordance with all the safety requirements, potential risks of
injury and damage remain. The following dangers can arise in connection with the structure and design
of this product:
• Health defects resulting from vibration emission if the product is being used over long periods of time or
not adequately managed and properly maintained.
• Injuries and damage to property due to broken application tools or the sudden impact of hidden objects
during use.
• Danger of injury and property damage caused by flying objects.
g) Service
• Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
• Never service damaged battery packs. Service of battery packs should only be performed by the
manufacturer or authorized service providers.
h) Drill safety warnings
• Wear ear protectors when impact drilling. Exposure to noise can cause hearing loss.
• Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal injury.
• Hold the power tool by insulated gripping surfaces, when performing an operation where the
cutting accessory or fasteners may contact hidden wiring. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live" and could give the operator an electric shock.
• Use clamps or another practical way to secure and support the workpiece to a stable platform.
Holding the work by hand or against your body leaves it unstable and may lead to loss of control and
potential injuries.
• To reduce the risk of explosion, electric shock and property damage, always check the work area for
hidden gas pipes, electrical wires or water pipes.
• Hold the power tool securely. When tightening and loosening the screws/bolts be prepared for temporarily
high torque reactions.
20