Beyerdynamic TG 500 Guide De Démarrage Rapide page 15

TG 500 – Operation
Receiver TG 500SR – rear
µ ¸
On/off button
Infrared interface for synchronisation of receiver
and transmitter
Backlit
Up button
Down button
Enter button
Exit button
• Connect the symmetrical XLR ¹ or jack ¸ TG 500SR to the symmetrical microphone input on the mixing con-
sole or the amplifier.
• Connect the supplied antennas to the antenna inputs A and B
(approx. angle of 60°).
• Connect the power supply to the DC connection
• Press the on/off button.
• Press the Enter button
• First select a suitable frequency range and a channel. To do this, we recommend the menu item "GR/CH". In this
menu you can select a pre-defined channel or frequency from a pre-defined frequency range. Each frequency
range contains several channels at a defined frequency spacing to each other. This has the advantage that du-
ring operation of multiple transmitters and frequencies, mutual interference by transmitters is avoided. If you want
to manually set an individual frequency, please refer to the TG 500 system manual, available on the web at
www.beyerdynamic.com.
• Use the Up or Down
• Press the Enter button
the Enter button again. Now you can select a channel (CH) using the Up
• To save the selection press the Enter button
CAUTION: It is not possible to operate two transmitters on the same channel at the same time.
• The output volume can be adjusted on the receiver via the "Gain" menu.
• If distortions occur, the Gain switch on the transmitter allows reducing the sensitivity.
• Subsequently the selected frequency and - if applicable - other settings must be transferred to the transmitter.
This is done via the synchronisation button
interface. With the transmitter switched on, hold the infrared interface of the handheld µ or pocket ¸ transmitter
located inside the open battery compartment directly in front of the infrared interface
press the synchronisation button
Important: Following each change of settings in the receiver menu, the transmitter must be synchronised. We
recommend to first adjust all settings on the receiver followed by synchronisation.
¹
and a power source.
.
buttons on the receiver to select the menu item "GR / CH".
. Now you can select a frequency range (GR) using the Up
again.
. The battery compartment of the transmitter contains an infrared
.
Button for synchronisation between receiver and
transmitter
Antenna in A or B
µ Frequency band
¸ Audio out, 3 pin jack
¹ Audio out, 3 pin XLR socket
DC connection for external power supply, 12 V DC,
500 mA
Strain relief for power supply cable
and orient them in a V-shape facing outwards
or Down
15
or Down button. Press
button.
of the receiver. Then