Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
For easy installation, select an existing light operated
by a wall switch for replacement.
For best performance, mount the fixture about
8 feet (2.4 m) above the ground.
❒ Drill the holes needed
to mount the backplate
to the junction box.
Eave Mount
For under eave installation, the sensor head must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.
For eave mount only:
❒ Rotate the sensor head towards the clamp screw
joint.
Joint Clamp
❒ Then rotate the sensor head clockwise 180° so the
controls face down.
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.
All manuals and user guides at all-guides.com
❒ Turn power off at the fuse or circuit breaker.
❒ Remove the existing light fixture.
❒ Route the Light Control's wires through the large
❒ Connect the junction box wires to the Light Control
Wall Mount
❒ Align the Light Control cover plate and the junction
❒ If not installed on a weatherproof box or if an adaptor
Control Switch
❒ Adjust the lamp holders by loosening the lock nuts
2
W
L
ire the
ight
gasket hole.
wires. Twist together and secure with a wire
connector.
Black to
Black
White to
White
M
L
ount the
box holes. Secure with the mounting screws.
plate (not included) was used, caulk the wall plate
and mounting surface with silicone.
Lock nuts
but do not rotate the lamp holders more than 180°
from the factory setting. When screwing in the flood-
lamps, do not overtighten.
C
ontroL
Gasket
C
ight
ontroL
Avoid water damage and
electrical shock - keep lamp
holders below horizontal.
Keep lamps at
least 1" (25 mm)
from the sensor.
598-1284-00
Publicité
Table des Matières
