Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
On-board computer
NOTE
With double action hydraulic cylinders the piston rod is pushed out or pulled in, as desired,
by virtue of the oil pressure. If the hydraulic valve is not actuated, the closed hydraulic valves
prevent the passage of oil and the hydraulics and the mounted implement remain fixed in the
last position.
NOTE
The floating function allows the mounted implement to rest on the ground by virtue of its own
weight. Oil flows freely through the open hydraulic valves enabling the mounted implement
to rise and fall independently to compensate for ground irregularities.
The on-board computer 16 is far more than simply a presentation of speed, time of day and
so on. This device is a small computer, which can also issue warnings if necessary.
Display functions:
When switching on the electrical system with the ignition key all displays illuminate on the
instrument panel for 2 seconds for checking purposes, followed by the travelling speed (up-
per line) and engine speed (lower line).
In the lower line appropriate information is given, depending on the function selected via 6
keys.
•
Key 1 has no function.
•
Water temperature is displayed by pressing key 2 (pilot lamp 2). Pressing this key again
switches to the previous mode.
•
Diesel fuel level is displayed by pressing key 3 (pilot lamp 3). Pressing this key again
switches to the previous mode.
•
Key 4 has no function.
•
Key 5 displays distance travelled in kilometres (pilot lamp 5). Pressing this key again
switches to the previous mode.
•
Key 6 displays operating hours (pilot lamp 6). Pressing this key again switches to the pre-
vious mode.
•
Key 7 displays the day counter for the operating hours (pilot lamp 7). Pressing this key
again switches to the previous mode. If the key is pressed for longer than 3 seconds, the
counter resets.
•
Key 8 displays the time of day (pilot lamp 8). Pressing this key again switches to the pre-
vious mode.
Setting the time of day: press keys 6 and 7 at the same time for 3 seconds. Now program
the current time of day using keys 5 to 8, one digit being assigned to each of these keys.
Then press keys 6 and 7 again for 3 seconds.
Warning functions:
-
Engine coolant temperature too high. If the engine coolant temperature rises to over
107 °C, pilot lamp 2 flashes and an audible warning sounds. At the same time the en-
gine coolant temperature is displayed in the lower line. A different function can be se-
lected (display in lower line), but the pilot lamp continues to flash. Only when the
upper line
lower line
pilot lamps 1 to 4
keys 1 to 4
keys 5 to 8
pilot lamps 5 to 8
77
Publicité
Table des Matières
