Installation And Location; Functional Description; Operating The Spray Gun; Preparation And Assembly - Kawasaki 691562 Mode D'emploi

RISK OF FLYING OBJECTS
Do not direct paint stream at people or pets. During cleaning and flushing, sol-
vents can be forcefully expelled from fluid and air passages. Some
solvents can cause eye injury. Be sure user and bystanders in the area are wear-
ing impact resistant eye and face protection. Even small projectiles can injure
eyes and cause blindness. Before operating the tool, make sure all the screws
& caps are securely tightened in case of leaking. Before painting, inspect the
Spray Gun for free movement of trigger and nozzle to insure tool can operate
well. Never modify this tool for any other applications. Only use parts, nozzles
and accessories recommended by manufactures. The powerful compressed
paint stream can damage exposed skin and easily propel loose dirt and other
small objects at high-speed, resulting in serious injury. Always wear eye protec-
tion that meets ANSI Z28.1 specifications. Never leave a Spray Gun unattend-
ed. Shut OFF Spray Gun and relieve pressure before performing maintenance or
repairs.
AIR TOOLS AND ACCESSORIES
Do not exceed the pressure rating of any air tools, spray guns, air accessories,
or inflatables. Excess pressure can cause them to explode, resulting in serious
injury. Follow the manufacturers recommended pressure settings for all air
tools and air accessories.

INSTALLATION AND LOCATION

DO NOT place Spray Gun in an area:
• Where there is evidence of oil or gas leaks.
• Where flammable gas vapors or materials may be present.
• Where air temperatures fall below 32ºF or exceed 104ºF.
7

FUNCTIONAL DESCRIPTION

7
3
4
2
5
1
9
6
10

OPERATING THE SPRAY GUN

Never aim or spray at yourself or anybody else which
would cause serious injury.

PREPARATION AND ASSEMBLY

1. After unpacking the product, inspect carefully for any damage that may have
occurred during transit. Make sure to tighten fittings, bolts, etc., before putting
unit into service. Tighten the gun to the cup securely using the connector with
filter inside.
2. Thoroughly mix and thin paint in accordance with the paint manufacturer's
instructions. Most materials will spray readily if thinned properly.
3. Strain material through filter, cheese cloth or a paint strainer.
4. Tighten the gun to the cup securely using the connector with filter inside.
5. Fill the cup about 3/4 full and start the air compressor.
CONTROLS AND
8
COMPONENTS:
1. Air Cap
2. Air Cap Nut
3. Cup Connector
4. Filter
5. Fluid Control Knob
6. Spray Pattern
Adjustment Knob
7. Cup Cover
8. Air Release Plug
12
9. Trigger
10. Air Volume Control
11
Knob
11. Air Inlet Coupling
12. Cup