Accessories - Black & Decker KD855 Traduction Des Instructions D'origine

ENGLISH
Selecting the operating mode (fi g. E)
The tool can be used in three operating modes.
Rotate the drilling mode selector (4) towards the
required position, as indicated by the symbols.
Drilling
♦ For drilling in steel, wood and plastics, and for
screwdriving set the operating mode selector
(4) to the position.
Hammer drilling
♦ For hammer drilling in masonry and concrete,
set the operating mode selector (4) to the
position
♦ When hammering, the tool should not bounce
and run smoothly. If necessary, increase the
speed.
Hammering
♦ For hammering with spindle lock, and for light
chiselling and chipping, set the operating mode
selector (4) to the
♦ Make sure the forward/reverse switch is in the
forward position.
♦ When changing from hammer drilling to
chiselling, turn the chisel to the desired
position. If resistance is felt during mode
change, slightly turn the chisel to engage the
spindle lock.
Selecting the direction of rotation
For drilling, for tightening screws and for chiselling,
use forward (clockwise) rotation. For loosening
screws or removing a jammed drill bit, use reverse
(counterclockwise) rotation.
♦ To select forward rotation, push the forward/
reverse slider (3) to the left.
♦ To select reverse rotation, push the forward/
reverse slider to the right.
Warning! Never change the direction of rotation
while the motor is running.
Setting the drilling depth (fi g. F)
♦ Slacken the side handle (6) by turning the grip
counterclockwise.
♦ Set the depth stop (7) to the desired position.
The maximum drilling depth is equal to the
distance between the tip of the drill bit and the
front end of the depth stop.
♦ Tighten the side handle by turning the grip
clockwise.
8
position.
Switching on and off
♦ To switch the tool on, press the variable speed
switch (1). The tool speed depends on how far
you press the switch.
♦ As a general rule, use low speeds for large
diameter drill bits and high speeds for smaller
diameter drill bits.
♦ For continuous operation, press the lock-on
button (2) and release the variable speed
switch. This option is available only in forward
(clockwise) rotation.
♦ To switch the tool off, release the variable
speed switch. To switch the tool off when in
continuous operation, press the variable speed
switch once more and release it.

Accessories

The performance of your tool depends on
the accessory used. Black & Decker and
Piranha accessories are engineered to high
quality standards and designed to enhance
the performance of your tool. By using these
accessories you will get the very best from your
tool.
Maintenance
Your tool has been designed to operate over a long
period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance,
switch off and unplug the tool.
♦ Switch off and unplug the appliance/tool.
♦ Or switch off and remove the battery from
the appliance/tool if the appliance/tool has
a separate battery pack.
♦ Or run the battery down completely if it is
integral and then switch off.
♦ Unplug the charger before cleaning it. Your
charger does not require any maintenance
apart from regular cleaning.
♦ Regularly clean the ventilation slots in your tool
using a soft brush or dry cloth.
♦ Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
♦ Regularly open the chuck and tap it to remove
any dust from the interior (when fi tted).