Publicité
Les langues disponibles
Les langues disponibles
Active Location of Utilities
Locating with the Receiver
1. Turn the Receiver on by pressing the
power button for two seconds. Hold the
Receiver vertically.
2. Press "Hz" button
33 kHz is selected.
3. Follow the steps as described in
"Locating with the Receiver"
the arrow indicators to quickly assess the
location of the wire (optionally, measure the
depth of the wire – refer to the User Manual
for more details).
repeatedly until
(Pg 2-4), using
500
©2018 Beha-Amprobe
©2018 Beha-Amprobe
For detailed specifications and ordering go to beha-amprobe.com 6011426 A
For detailed specifications and ordering go to beha-amprobe.com 6011426 A
®
®
Note: For better accuracy, move the Transmitter
directly over the location of the utility after its
detection.
Note: If the arrows indicate a different target
position than the largest bar graph reading,
signal distortion is present. Use the bar graph
to pinpoint the line as it is influenced less than
the arrows in a distorted signal field.
Quick Guide
7
Publicité
