Horizon Global 75912 Instructions D'installation

Frame rail
Vehicle forward
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75912F
Wrenches: 15mm, 3/4
Drill Bits: None
Slowly start the first few
threads keeping the bolt
perpendicular to the frame rail.
S elf-tapping bolts method
j
Qty. (2) Carriage bolt 1/2-13 X 1.50 GR5
k
Qty. (2) Spacer .25 X 1.00 X 3.00
l
Conical w asher 1/2"
Qty. (2)
1. Start by threading the self-tapping bolts (item 5) into the locations, as shown in illustration above. The bolts have a self-aligning
feature. Start the first few threads slowly keeping them perpendicular to the frame rail. Thread the bolt ½ way or more in to the
frame rail, then remove the bolt to be reinstalled later.
2. Feed the coiled end of the pull wire through the forward slot in the frame rail and out the open end of frame rail. Attached carriage
bolt and spacer to the pull wire. Pull the pull wire with fasteners into location though the forward hole. Leave pull wires attached.
3. Raise hitch into position feeding the pull wires through the adjacent slots on the hitch. Feed conical washer over pull wire , using
the washer to hold the bolt in place remove the pull wires and attach the hex nut. Tighten to hold hitch in place, repeat on
opposite frame rail.
4. Re-install the self-tapping bolts. Once all bolts are in place center hitch on vehicle and tighten.
5. Torque all fasteners to specifications below.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and
exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when worki ng beneath a vehicle and wear eye protection. Do not cut
access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of N ew York, V.E.S.C. Regulation V-5 and SAE J684.
© 2014, 2015, 2021 Horizon Global™ Corp. - Printed in Mexico
Installation Instructions
Bumper
Frame rail open for
access for carriage
bolt and spacer.
Frame rail
n
Tighten all fasteners M 12 X 1.75 with torque wrench to 75 Lb.-Ft. (102 N*M )
Tighten all fasteners ½-13 Gr 5 with torque wrench to 75 Lb.-Ft. (102 N*M )
Ford Transit
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1,2
Note: Fasteners typical
Self-tapping bolts locations
m
Qty. (2) Hex nut 1/2-13
n
Qty. (4) Self-tapping bolt M12 X 1.75 X 40
o
Pull w ire 1/2"
Qty. (2)
Sheet 1 of 3
Printed in Mexico
Part Numbers:
75912
44719
CQT75912
Max Gross
T railer WT (LB)
8000 (3632 Kg)
6000 (2722 Kg)
both sides
n
o
75912N 09-14-21
Form: F205 Rev C 9-17-2012
Max T ongue
WT (LB)
900 (408 Kg)
900 (408 Kg)
j
k
l
m
Rev. D