Ahrend 500 Mode D'emploi page 33

Drawer pedestals
There are several types of drawer pedestals - desk-height
pedestals for use alongside a table, two types of
pedestals on castors that can be wheeled under a table,
trolleys and suspended drawer pedestals.
Mobile drawer pedestal
The mobile drawer pedestal with push-handle is easy to
move over relatively long distances, for example in an
office with flexible workstations (fig. 1).
Suspended drawer pedestal
The suspended drawer pedestals can be used under
tables with C legs as well as N legs. They are hung on
the beam, directly under the top (fig. 2). The drawer
pedestals are 60 cm deep.
Keys
Drawer pedestals are supplied with two keys, one of
which has a hinged plastic grip.
Moving the mobile drawer
pedestal
Lock the unit first so that the
drawers cannot slide open while
it is being moved. This pedestal can
be either pushed or pulled
as required.
32
The number on the key corresponds to the number on
the lock. You will need to quote this number when
re-ordering keys. The whole cylinder of the lock, with
key, can also easily be replaced so that the unit can be
locked (and unlocked) with a different key.
Drawer handles
The drawer fronts either have a handle over the full
width (fig. 2) or side grips on each side of the drawer
(fig. 3).
Drawer types
Only telescopic drawers can be pulled all the way out of
the unit.
Maximum drawer loads
Materials drawer
Single drawer
Telescopic drawer
Never stand or sit on an open drawer.
Unlocking the unit
Insert the key into the lock and turn
it 90 degrees clockwise. Any desired
drawer can now be opened. When
this has been done, the other draw-
ers are all immobilised.
The key can be left in the lock or
removed.
English
5 kg
20 kg
39 kg
Locking the unit
Close all drawers. Insert the key in
the lock and turn it 90 degrees
anticlockwise. The drawers are now
locked, and the key can be
removed.
1
3
Changing the cylinder
Lock the unit. Now turn the key
slightly to the right, till the notch
on the edge of the cylinder is at
'3 o'clock'. A deblocking pin can
be inserted in the notch in this
position. Pull the cylinder, with key
and deblocking pin, from the barrel
of the lock.
2
4
Insert the new cylinder, with the key
in it, into the barrel and push it in
until it clicks in place.