Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALL HOOD
1
Hang hood from (4) Mounting Screws (from parts bag). Slide
hood towards wall until mounting screws are engaged in
narrow end of (4) Keyholes. Tighten mounting screws
securely.
CAUTION
DO NOT PUSH ON FAN BLADE. Pushing on the
blade may cause it to interfere with other hood parts.
2
Connect ductwork to hood. Use Duct Tape to make joints
secure and air tight.
3
Install (2) PAR20, 50 W Maximum Halogen Bulbs or (2) R16,
40 W Maximum Incandescent Bulbs. Purchase bulbs
separately.
!
CAUTION:
Bulbs may be hot! Refer to bulb packag-
ing for further information.
4
Replace filters and make sure fan blade turns freely. Turn on
power at service panel, and test for proper operation.
All manuals and user guides at all-guides.com
NON-DUCTED FILTERS
If hood is to be installed Non-Ducted:
Purchase a set of (2) non-ducted filters from your local distributor
or retailer and attach them to the aluminum mesh filters.
KEYHOLE
OPERATION
(4)
MOUNTING
SCREW
(4)
Fan: The 3-position rocker switch (on the left) controls the fan.
The left position is low speed, center position is off, and right
position is high speed. An indicator light shows that the fan is on.
Light: The 3-position rocker switch (on the right) controls the lights.
The left position is low light intensity, center position is off, and
right position is high light intensity.
DUCT
TAPE
CLEANING
Aluminum mesh filters: Clean frequently using hot water and a
mild detergent. Filters are dishwasher safe.
Charcoal filters: Clean filter surfaces frequently with a damp cloth
and a mild detergent. DO NOT immerse filters in water or put in
dishwasher. The special "Clean Sense" feature indicates when the
filter is to be replaced. The blue and yellow strips will blend to
PAR20,
green when it is time to change the filter. The "Clean Sense"
50W MAX.
feature works best when facing toward the cooking surface.
HALOGEN
To clean hood: Remove filters. Use a damp cloth and a mild
BULB (2)
detergent to wipe all grease-laden surfaces. Use care when
- or -
cleaning fan blade - it must not become bent or misaligned. DO
R16,
NOT ALLOW WATER TO ENTER MOTOR. Make sure all surfaces
40W MAX.
are completely dry before re-installing filters and restoring power.
INCANDESCENT
Motor is permanently lubricated. Do not oil or disassemble motor.
BULB (2)
ALLURE
WARNING: To reduce the risk of electric shock,
disconnect from power supply before cleaning.
®
WS1 SERIES
RANGE HOOD
Page 5
Publicité
Table des Matières
