Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE HOOD
WIRING
COVER
3
Remove Wiring Cover from inside the hood. Set cover and
mounting screw aside.
4
Remove either top or back wiring knockout and install
approved Electrical Cable Clamp.
Ducted Installation - Skip to Step 10.
The following Steps (5 thru 9) are for
NON-DUCTED INSTALLATION ONLY.
(3) #8 SCREWS
(2) #8 SCREWS
5
Remove Light Panel - held in place with (3) #8 screws and
(2) #8 screws. Disconnect light assembly wire harness
(white connector).
All manuals and user guides at all-guides.com
PREPARE THE HOOD
ELECTRICAL
CABLE CLAMP
LIGHT
PANEL
AIR CHUTE
6
Remove Air
Chute - held in
place with one
(1) screw.
NOTE: Be
careful not to
disconnect any
wires.
7
Remove Baffle
from air chute.
Tabs will
disengage
from Slots.
8
Rotate baffle. Reinsert
baffle into air chute (as
shown) so that baffle fits
all the way into
into air chute. An
audible "click" will
be heard when
fully installed.
This will direct
air flow through
the non-ducted
slots on top
of hood.
9
Re-install air chute and screw,
re-connect wire harness, and replace light panel.
NOTE: Be careful not to trap wires between Support Fin
and light panel.
ALLURE
®
WS1 SERIES
RANGE HOOD
Page 3
BAFFLE
TABS
SLOTS
SUPPORT FIN
Publicité
Table des Matières
